SMART 10/100 +2 Gigabit UpLink 19" Switch
The FGSW-2620RS provides 24 10/100Mbps Fast Ethernet ports and two Gigabit Ethernet ports, either TP or SFP per port. The two Gigabit ports either can be 1000Base-T for 10/100/1000Mbps or 1000Base-SX/LX through SFP (Small Factor Pluggable) interface. The distance can be extended from 100 meters (TP), 550 meters (Multi-mode fiber), up to above 10/50/70/120 kilometers (Single-mode fiber).
The FGSW-2620RS, equipped with non-blocking 8.8Gbps backplane, greatly simplifies the tasks of upgrading your LAN for catering to increase bandwidth demands. For efficient management, the FGSW-2620RS 24-Port 10/100Mbps + 2 Gigabit TP / SFP combo Ethernet Smart Switch is equipped with console interface.
The FGSW-2620RS can be programmed for basic switch management functions such as port speed configuration, Port Trunking, VLAN, QoS, bandwidth control, and IGMP Snooping.
The FGSW-2620RS provides port-based VLAN (including overlapping). The VLAN groups, allowed on the FGSW-2620RS, will be maximally up to 26 for port-based VLAN. Via supporting port trunking, the FGSW-2620RS allow the operation of a high-speed trunk combining multiple ports. The FGSW-2620RS also provide eight groups of up to 4-ports for trunking, and it supports fail-over as well.
Workgroup Switch
With 24 10/100Mbps ports and up to two copper or Gigabit-Ethernet fiber ports, the FGSW-2620RS provides a cost-effective, high-performance solution for power users.
Department Switch
With its 8.8 Gigabits per second, non-blocking switch fabric, the FGSW-2620RS can easily provide a local, high bandwidth, Fast Ethernet network for backbone of your department. With the two SFP ports, the FGSW-2620RS provides the uplink to the backbone network through Gigabit Ethernet LX / SX SFP modules.
Key Features
- Complies with the IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z Gigabit Ethernet standard
- 24-Port 10/100Mbps Fast Ethernet Switch
- 2 10/100/1000Mbps ports and 2 SFP interfaces
- Each Switching ports support auto-negotiation-10/20, 100/200Mbps supported
- Auto-MDI/MDI-X detection on each RJ-45 port
- Prevents packet loss with back pressure (half-duplex) and IEEE 802.3x PAUSE frame flow control (full-duplex)
- High performance Store and Forward architecture, broadcast storm control, runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth
- 8K MAC address table, automatic source address learning and ageing
- 2.5Mbit embedded memory for packet buffers
- Console interface for Switch basic management and setup
- Supports up to 26 port-based VLAN groups
- Supports up to 6/8 Trunk groups, each trunk for up to maximum 4 port with 800Mbps bandwidth
- Supports QoS and bandwidth control on each port
- Supports IGMP Snooping
- EMI standards complies with FCC, CE class A
Hardware Specification |
|
Ports |
24 10/100Base-TX RJ-45 Auto-MDI / MDI-X ports |
Gigabit ports |
2 10/100/1000Mbps ports and 2 SFP interfaces |
Switch Processing Scheme |
Store-and-forward |
Throughput |
6.54Mpps (packet per second) |
Switch fabric |
8.8Gbps |
Address Table |
8K entries |
Share data Buffer |
2.5 Mbit |
Flow Control |
Back pressure for half duplex, IEEE 802.3x Pause Frame for full duplex |
Dimensions |
440 x 120 x 44 mm (1U height) |
Weight |
FGSW-1820RS:1.46 kg |
Power Requirement |
100~240 VAC, 50-60 Hz |
Power Consumption / Dissipation |
23.1 watts / 78BTU |
Temperature |
Operating: 0~50 degree C |
Humidity Operating: |
5% to 90%, Storage: 5% to 90% (Non-condensing) |
Smart function |
|
System Configuration |
Console interface |
Port configuration |
Port disable/enable. Auto-negotiation 10/100Mbps full and half duplex mode selection. Flow control disable / enable. Bandwidth control on each port. |
Port Status |
Display each port¡¦s speed duplex mode, link status, Flow control status. Auto negotiation status, trunk status. |
VLAN |
26 port-based VLAN groups |
Port trunking |
Support 8 groups of 4-Port trunk support |
QoS |
Allow to assign high priority on each port |
IGMP Snooping |
Allow to disable or enable. |
Standards Conformance |
|
Regulation Compliance |
FCC Part 15 Class A, CE |
Standards Compliance |
IEEE 802.3 (Ethernet) |
back to previous page